Home > Flight Simulator Airline Crew Simulations > Aerosoft Airbus X Series > Voice Control > Procedures > Go Around Procedures
Go Around Procedures
To initiate a go around, advance the throttles to TOGA.
“GO AROUND FLAPS"
The FO will move the flaps one level up, and call “POSITIVE RATE” when a positive rate of climb has been established.
After the FO has called "Positive Rate" make the following commands:
“GEAR UP”
Clean the aircraft up as you would doing a normal climb.
Call for the “AFTER TAKEOFF CHECKLIST” after the aircraft is in a clean configuration.
Continue to the alternate airport or shoot the approach again. If shooting the approach again, cycle the Mode to “LANDING” before calling for Flap Extensions, Landing Gear and commencing the 'Landing Checklist'.
Notes:
- For the “GO AROUND” call to take effect in the simulation, the FS2Crew Display Mode on the Main Panel must display: 'LANDING'.