Home > Flight Simulator Airline Crew Simulations > PMDG 737 NGX (Legacy Version) > Voice Control > FS Video Marshaller

FS Video Marshaller

Select versions of FS2Crew include, as an added bonus, a special version of FS Video Marshaller.

Using the FS Video Marshaller is an optional enhancement for the simulation.  It is not a requirement for the correct running of FS2Crew.

VERY IMPORTANT:  YOU MUST RUN IN 'WINDOWED' MODE, NOT 'FULL SCREEN' MODE WHEN ATTEMPTING TO A PLAY A FS VIDEO MARSHALLER VIDEO OR YOU WILL GET A CRASH.  THIS IS A RESULT OF AN FSX IMPOSED LIMITATION.  PRESS 'ALT - ENTER' ON YOUR KEYBOARD TO CYCLE VIDEO MODES!

Step 1:

To setup FS Video Marshaller, uncheck "PAUSE ON TASK SWITCH' found in the FSX's 'SETTINGS - GENERAL' menu as shown below:







Step 2:




LEFT SCREW:

• Open the video panel so it can be dragged to a new position.  Left click again to close.

CHOCKS IN:

• Wheel chocks in.

CHOCKS OUT:

• Wheel chocks out.

ENG 1:

• Start Engine 1.

ENG 2:

• Start Engine 2.

GPU CON:

• Connect Ground Power Unit (GPU).  External PWR and AIR will connect to the 737.

GPU DISC:

• Disconnect Ground Power Unit (GPU).  External PWR and AIR will disconnect from the 737.

WAVE OFF:

• Wave off the ground crew when ready to taxi.

LIGHT:

• Toggles night lighting on/off.

RIGHT SCREW:

• Closes the Video Marshaller Panel.

Notes:

To move the FS Video Marshaller video window to a different monitor or reposition it on the screen:

1. Open the Video Marshaller panel.
2. Left click the left screen on the panel.
3. The video player window will pop-up.
4. Drag the video player window to your desired location.
5. Left click the left screw again to close the video player window (you may need to click it twice as your Flight Simulator window may be out of focus.