Home > Flight Simulator Airline Crew Simulations > Aerosoft Airbus X Series > Voice Control > Procedures > Rejected Takeoff Procedures

Rejected Takeoff Procedures


To initiate a Rejected Takeoff, speak: “STOP”.

Perform the following:

  1. Thrust Levers Idle.
  2. Reverse Thrust Maximum Available.


FS2Crew will change to ROLL-OUT mode.

When the aircraft stops:

  1. Reverse Stowed.
  2. Parking Brake Apply.
  3. PA: "ATTENTION CREW AT STATIONS".

If Evacuation is required:

  1. Engine Master (All) Off.
  2. PA: "THIS IS THE CAPTAIN -EVACUATE, EVACUATE, EVACUATE"


When you exit the runway, you have two options:

1.    If you are returning to the gate, disarm the ground spoilers. 

The FO will then perform his normal After Landing flow and you can return the gate as per a normal after landing/arrival sequence.

Or:

2.    If you want to taxi back for another takeoff, speak: “LETS TAXI BACK TO THE RUNWAY”.

You will then need to run the Before Takeoff Checklist again.