Home > Flight Simulator Airline Crew Simulations > PMDG 737 NGX (Legacy Version) > Voice Control > Quick Start Guide > PMDG 737 NGX SPECIAL BUNDLE PACK- VOICE

PMDG 737 NGX SPECIAL BUNDLE PACK- VOICE

1. Ensure you have SP1c installed.  SP1c is ONLY available in the PMDG Support Forum at Avsim.   If in doubt, re-install it.  SP1b is NOT sufficient.  If SP1c or later is not installed, FS2Crew will not function properly!
2. Setup Speech Recognition.  Don't forget to train your Voice! 
3. Go to Windows Control Panel -> Hardware and Sound -> Sound -> Communications.  Select "Do Nothing" when Windows detects communication activity and click apply.
4. Open the FS2Crew PMDG 737 Configuration Manager and press the "Enable FS2Crew Voice Control" button.  (Important:  Ensure UAC is disabled and run the Config Manager as an Admin).
5. Setup Soft Mute and Hard Mute.
6. Learn how to open the FS2Crew Main panel.
7. Ensure your NGX loads by default into the 2D Cockpit, and not the VC or you may trigger an "SDK Warning".
8. Ensure the default aircraft loaded by FSX is NOT the NGX or any other 3rd party aircraft, but rather the Trike.  (This is also a PMDG recommended procedure).
9. Read how the in-simulation FS2Crew Main and Configuration panels operate.
10. Print out the Flows manual.
11. Print out the Voice Commands and Voice Checklist Manual.  This is the heart of the simulation.  You MUST print this section otherwise you will be lost!
12. Ensure the PMDG 737 NGX's built in FO callouts are disabled.
13. If you have any problems, check the Troubleshooting section.